Profile Info

Modify Profile

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - eaty

Pages: [1] 2 3
1
Eaty / Re: Eaty System V 2
« on: November 09, 2009, 05:45:29 am »
Recently i improve my trading skill by using Tread Lines.

By adding this skill i able to :
a. Know where the price will end. (Best for TP)
b. Know whether this is a good entry.
c. Know the trend of the current market.
d. Filter some lousy entry.

How to draw a TL?
My recommendation is minimum connect 3 area. Show below.

As can see the round blue show that 3 area of resistance. Base on this single TL we able to filter, get out at the best point and going in the correct trend.

If you can master the TL, ur trading skill is higher one level. TL is another big topic to understand so u should pay attention on it. It can save ur acc from being burn and help u to see the future of the market. It is like a crystal ball for us fx trader.

I just show a small bite of the power of TL. Knowing TL is 1 thing how to apply it is another thing.

Hope it help.

2
Eaty / Re: Eaty EA files
« on: September 15, 2009, 01:49:21 pm »
for the moment no. Sorry dude.

3
Eaty / Re: Eaty EA files
« on: September 01, 2009, 06:18:25 am »
I chked the backtest result. Although there are some error think it might be the historical data corrupted. So i will do demo on live see how it do.

Here i would like to thank you Xux ag. You are the best.


4
Eaty / Re: Eaty EA files
« on: August 29, 2009, 05:57:58 am »
heh man just to inform you that i done backtest but i am away until monday. So i will let you guy know about the EA.

5
Eaty / Re: Eaty EA files
« on: August 25, 2009, 03:10:57 pm »
sorry , i just back home from the weekend. I will let u know after i backtest.

6
Eaty / Re: Eaty EA files
« on: August 18, 2009, 05:10:02 pm »
I could not repeat the problem of repeated entries and exits on the same bar, it may be caused by corrupted historical data.

Agree with this corrupted historical data might cause alot of problem.

Pic 1. show that the EA never BE+1 for me even after our 50 pips target hit. Trade 2 & 3 still lose more then BE+1.

You should use every tick for your backtests, look at the statement of my backtest using every tick.

Yeap i am using every tick.

Pic 2. Show that the Buy entry is not open even it hit out Entry.

Which date did it happen? I would like to run a backtest myself.

I try run it again and this problem fix. So i think it is not your error. It might b backtest problem on data corrupted.

Pic 3. I believe this is the error we discuss earlier.
c. Pic 2, the blue line is the entry. Can explain the starting SL. When it move on, SL move to BE+1 > 30 pips. The question is at E3 and E3.1. The SL move to E3, which is the high E3 bar and E3.1, which is the high of E3.1 bar.
By right, the SL move from BE+1 > 30 > SL at the high of E3.2. Because it form a new high at RSI.
Why SL move to the high of E3.3?
It should move to E3.4 as PA close above the 4MA.

SL dont move when RSI move higher. It move when it form a highest high or lowest low. So in our example SL > Pivot high > BE+1 > 30 > E3 > E3.4. For further detail pls refer to SL case3.

Stop loss moved to the high of E3.3 because we have a new local RSI high. Would you like to code the EA so that it moves SL only if we have an all time RSI high since the entry time?

Yeah recode the EA but not all time RSI high. It is the time it form the triangle in the RSI. Shown in picture below. for buy rsi1 > rsi2 < rsi3. for sell rsi1 < rsi2 > rsi3.

Lastly, Xux can you edit the EA to depend on RSI cross to enter signal and not on MACD. Shown in pic 4 below. Beside that i am not sure about the SL shown in the pic 4, a bit off.

OK, in the next version MACD will just confirm the signal, only an RSI cross of 50 can trigger an entry signal.

yeah that is what i mean.

Thank you in advance.


7
Eaty / Re: Eaty EA files
« on: August 18, 2009, 04:45:48 pm »
i will look into it tomorrow. Sorry for the delay.

8
Eaty / Re: Eaty EA files
« on: August 17, 2009, 07:38:58 am »
Pic 1. show that the EA never BE+1 for me even after our 50 pips target hit. Trade 2 & 3 still lose more then BE+1.

Pic 2. Show that the Buy entry is not open even it hit out Entry.

Pic 3. I believe this is the error we discuss earlier.
c. Pic 2, the blue line is the entry. Can explain the starting SL. When it move on, SL move to BE+1 > 30 pips. The question is at E3 and E3.1. The SL move to E3, which is the high E3 bar and E3.1, which is the high of E3.1 bar.
By right, the SL move from BE+1 > 30 > SL at the high of E3.2. Because it form a new high at RSI.
Why SL move to the high of E3.3?
It should move to E3.4 as PA close above the 4MA.

The stop loss moved to E3.3 because RSI was higher than the previous bar. Should it move only if RSI is highest from the time the order is opened and not just higher that the previous bar?

SL dont move when RSI move higher. It move when it form a highest high or lowest low. So in our example SL > Pivot high > BE+1 > 30 > E3 > E3.4. For further detail pls refer to SL case3.


Lastly, Xux can you edit the EA to depend on RSI cross to enter signal and not on MACD. Shown in pic 4 below. Beside that i am not sure about the SL shown in the pic 4, a bit off.

Thank you in advance.

9
Eaty / Re: Eaty EA files
« on: August 16, 2009, 03:43:50 pm »
Just an update on the backtest result that i had done. Haven't chk whether got error or not.

10
Eaty / Re: Eaty EA files
« on: August 15, 2009, 12:31:29 pm »
Hi,

Newbie here too. In backtesting do we need to chk the optimization? With and without what is the different?

Thank you in advance

11
Eaty / Re: Eaty EA files
« on: August 15, 2009, 07:01:15 am »
just curios y this happen?

12
Eaty / Re: Eaty EA files
« on: August 14, 2009, 04:55:47 pm »
i not sure why but when i backtest it keep open multiple trade at the wrong point... pls see the report attached

13
Eaty / a quick update on lastest EA back testing
« on: August 14, 2009, 04:21:41 pm »
i been doing the backtesting but with alot of problem such as power failure, pc restart, accidentally off my platform bla bla bla... so end up i cant really backtest the EA yet. I am still trying to back test it hope i able to do it by this week.

14
Eaty / Re: Eaty EA files
« on: August 14, 2009, 02:41:36 am »
hmm... i found that the system work well with alpari GMT but the spread is expensive, 10pips. Any other broker that hv the same GMT like alpari? I believe their GMT is +2. Not really need GMT + 2, we can use GMT + 6, GMT + 10, GMT + 14, GMT + 18 ...

For better result pls backtest at platform with GMT +  2, for the moment i know is alpari. The result is totally different.

15
Eaty / Re: Eaty EA files
« on: August 13, 2009, 04:50:05 pm »
Q1. Yeap, H4 candles differently from the chart.

Pages: [1] 2 3